Recommended Printers: Color Laser Copiers • Cannon 300, 320, 350, 500, 550, 700, 800 • SAVIN CS106 • Kodak 1525, 1550 • Ricoh NC 5006 .

Items needed: Computer, Graphics Software, Color Laser Copier, Universal™ Transfer Paper, Heat Press
Recommend Application
Application Instructions:

1) CREATE DESIGN - Using graphics software, create a design and output to your laser copier. Fan sheets prior to loading. *Be sure to print your design in the REVERSE / MIRROR format.

2) CUT DESIGN - Cut transfer paper to size (no larger than 3" x 8" for mugs). Handle transfer carefully. Toner will flake off paper if mishandled.

3) HEAT APPLY -
FOR USE WITH ANY MUG PRESS WITHOUT A BUILT-IN THERMAL MUG PAD - Apply the design for 60 seconds at 305º F using LIGHT / MEDIUM pressure. *Taped transfer must be wrapped with Thermal Mug Pad before heat application. The mug MUST be glazed immediately after application. PEEL HOT!

FOR USE WITH ANY MUG PRESS WITH A BUILT-IN THERMAL MUG PAD - Apply the design for 60 seconds at 265º F using LIGHT / MEDIUM pressure. *The mug MUST be glazed immediately after heat application. PEEL HOT!

4) GLAZE - Immediately after heat applying, place inverted mug in glazer unit and press button. Be sure the edge of the mug rests on the white button inside the glazer. Do not touch the light bulb with fingers or mug. Once the mug has glazed, the green light will turn off automatically. *After removing the mug from the glazer, allow mug to cool. (If desired, place mug in cool water.)

IMPORTANT:

* Please keep your UNIVERSAL™ paper in the plastic bag until actual use. This will keep moisture out of the paper. Close the bag after each use.

* The print area on the mug should not exceed 3" x 8".

  

All technical information and recommendations are based on tests we believe to be reliable. However, we cannot guarantee performance under conditions not under manufacturer's control. Before using, please determine the suitability of product for it's intended use. The user assumes all risk and liability whatsoever in connection with the use of this product. Seller's and manufacturer's only obligation shall be to replace such quantity of the product proved to be defective by the manufacturer.