Recommended Substrates: White of light colored 100% cotton, 100% Polyester, Poly / Cotton blends

Items needed: Computer, Graphics Software, Laser printer, Techni-Print Transfer Paper, Heat Press
Recommend Application
Application Instructions:

1) CREATE DESIGN - Using graphics software, create a design and output it to your laser printer. Remember to use the by-pass tray and select a thick paper setting. Don’t forget to mirror your design.

2) PRINT DESIGN - Feed the short edge of paper into printer. Fan sheets prior to loading to make sure they are loose. *Trim the excess paper around the design when printing is complete.

3) PREHEAT GARMENT - It is extremely important to preheat the garment before application. Press garment for 1-2 seconds to remove moisture and chemical treatment from the transfer area.

4) POSITION DESIGN - Position the design as you want it on the garment. Place a protective cover sheet over the design.

5) HEAT APPLY - Heat apply the design for 15-20 seconds at 400º F using HEAVY of pressure.

6) PEEL and REVEAL - For best results, wait 3-5 seconds for a T-shirt and 5-10 seconds for a sweatshirt before peeling transfer sheet. PEEL HOT!


TIPS :
*Best performance is obtained on cotton, polyester, poly/cotton blends.

*A conventional home iron will not provide a satisfactory image transfer however, to brighten the image after washing, place a piece of white paper over the image and press with an iron on medium setting.­

IMPORTANT: Please keep your Techni-Print transfer paper in the plastic bag until actual use. This will keep moisture out of the paper. Close the bag after each use. 		 
CARE INSTRUCTIONS:
** Wait 24 hours after heat application before machine washing the decorated good.
** Turn garment inside out & machine wash in warm or cold water using mild detergent.
** Do not bleach.
** Tumble dry at a low setting.
** Do NOT iron directly over design.
** Do NOT dry clean.

All technical information and recommendations are based on tests we believe to be reliable. However, we cannot guarantee performance under conditions not under manufacturer's control. Before using, please determine the suitability of product for it's intended use. The user assumes all risk and liability whatsoever in connection with the use of this product. Seller's and manufacturer's only obligation shall be to replace such quantity of the product proved to be defective by the manufacturer.