Recommended Substrates: Dark color 100% cotton, 100% Polyester, Poly / Cotton blends & fleece.

Items needed: Computer, Graphics Software, Inkjet printer, IW Inkjet Opaque Transfer Paper, Heat Press
Recommend Application
Application Instructions:

1) CREATE DESIGN - Using graphics software, create a design and output to your ink jet printer. Fan sheets prior to loading. *Do NOT mirror your design.

2) CUT DESIGN - Cut around the design so as not to leave a border.

3) PREHEAT GARMENT - It is extremely important to preheat the garment before application. Press garment for 5-10 seconds to remove moisture and chemical treatment from the transfer area.

4) REMOVE DESIGN - Remove the cut design from its green-striped paper backing.

5) POSITION DESIGN - Position the design with logo facing upwards on the garment. Place a protective cover sheet over the design.

6) HEAT APPLY - Heat apply the design for 12 seconds at 340º F using LOW / MEDIUM pressure. Remove cover sheet immediately.

IMPORTANT: Please keep your IW Inkjet Opaque paper in the plastic bag until actual use. This will keep moisture out of the paper. Close the bag after each use.

Best performance is obtained on cotton, polyester & poly/cotton blends.		  
CARE INSTRUCTIONS:
** Wait 24 hours after heat application before machine washing the decorated good.
** Turn garment inside out & machine wash in warm or cold water - mild detergent.
** Do not bleach.
** Tumble dry at a low setting.
** Do not iron directly over the design.
** Do not dry clean.

All technical information and recommendations are based on tests we believe to be reliable. However, we cannot guarantee performance under conditions not under manufacturer's control. Before using, please determine the suitability of product for it's intended use. The user assumes all risk and liability whatsoever in connection with the use of this product. Seller's and manufacturer's only obligation shall be to replace such quantity of the product proved to be defective by the manufacturer.