Recommended Printers: All ink jet and bubble jet printers • Recommended for use with original equipment manufacturer inks only. Not recommended for use with generic inks or refilled ink cartridges.

Recommended Substrates: White or light color Cotton, Polyester, Poly / Cotton blends & fleece.

Items needed: Computer, Graphics Software, Ink Jet or Bubble Jet Printer, Inktra™ Transfer Paper, Heat Press
Recommend Application for INKTRA™ Transfer Paper
Application Instructions:

1) CREATE DESIGN - Using graphics software, create a design and output to your ink jet or bubble jet printer. Fan sheets prior to loading. *Be sure to print your design in the REVERSE / MIRROR format. Do not cut 11" x 17" paper in half before cutting.

2) CUT DESIGN - Depending on your design, you may choose to use scissors and cut around the design so as not to leave a border.

3) PREHEAT GARMENT - It is extremely important to preheat the garment before application. Press garment for 5-10 seconds to remove moisture and chemical treatment from the transfer area.

4) POSITION TRANSFER - After preheating the garment, position the design face down onto the garment. *There is no need for a cover sheet.

5) HEAT APPLY - Heat apply the design for 12-15 seconds at 375º F using HEAVY pressure. Peel away backing immediately. PEEL HOT!

IMPORTANT: Please keep your Inktra™ paper in the plastic bag until actual use. This will keep moisture out of the paper. Close the bag after each use.

Best performance is obtained on cotton, polyester, poly/cotton, 50/50 blends.		  
CARE INSTRUCTIONS:
** Turn garment inside out & machine wash in warm or cold water - mild detergent.
** Tumble dry at a low setting.
** Do not bleach.
** Do not iron directly over the design.
** Do not dry clean.

All technical information and recommendations are based on tests we believe to be reliable. However, we cannot guarantee performance under conditions not under manufacturer's control. Before using, please determine the suitability of product for it's intended use. The user assumes all risk and liability whatsoever in connection with the use of this product. Seller's and manufacturer's only obligation shall be to replace such quantity of the product proved to be defective by the manufacturer.