Recommended Application - For Cottons, Polyester & Poly/Cotton blends
Application Instructions:

1 - COLOR DESIGN

1) PREHEAT - Preheat garment at a temperature of 320º F for 4 seconds to remove moisture and wrinkles.

2) WEED - Weed excess material away from your precut names and/or numbers. If your names and/or numbers are already weeded, proceed to step 3.

3) POSITION - Position names and/or numbers face down on garment.

4) APPLY - Apply SPECTRA™ Cut Plus team names and/or numbers to substrate for 2 - 4 seconds at a temperature of 320º F using LIGHT pressure.

5) PEEL - After garment has completely cooled, remove mylar backing from SPECTRA™ Cut Plus Cuts. PEEL COLD!

6) COVER & APPLY - Cover the garment and SPECTRA™ Cut Plus Cuts with a Teflon sheet and heat press for an additional 10 seconds at temperature and pressure listed above. PEEL HOT! 		 
2 - COLOR DESIGN

1) REPEAT - Repeat steps 1-5 above.

2) POSITION - Position the second layer of SPECTRA™ Cut Plus Cuts over top of the first layer.

3) APPLY - Heat apply at 320º F for 4 seconds using LIGHT pressure.

4) PEEL - After the garment has completely cooled, remove the mylar backing from SPECTRA™ Cut Plus Cuts. PEEL COLD!

5) COVER & APPLY - Cover the garment and SPECTRA™ Cut Plus Cuts with a Teflon sheet and heat press for an additional 10 seconds at temerature and pressure listed above. PEEL HOT!
CARE INSTRUCTIONS:
** Machine wash using mild detergent at 176 º F max.
** Dry at a normal dryer setting on household machines.
** Do not iron directly onto this material.
** Do not dry clean.

All technical information and recommendations are based on tests we believe to be reliable. However, we cannot guarantee performance under conditions not under manufacturer's control. Before using, please determine the suitability of product for it's intended use. The user assumes all risk and liability whatsoever in connection with the use of this product. Seller's and manufacturer's only obligation shall be to replace such quantity of the product proved to be defective by the manufacturer.