Recommended Application - For Cottons, Polyester & Poly/Cotton blends
Application Instructions:

1 - COLOR DESIGN

1) PREHEAT - Preheat garment at a temperature of 302º F for 4 seconds to remove moisture and wrinkles.

2) WEED - Weed excess material away from your precut names and/or numbers. If your names and/or numbers are already weeded, proceed to step 3.

3) POSITION - Position names and/or numbers face down on garment.

4) APPLY - Apply SPECTRA™ Cut II Cuts team names and or numbers to substrate for 10 - 15 seconds at a temperature of 302º F using MEDIUM pressure.

5) PEEL - After garment has completely cooled, remove mylar backing from SPECTRA™ Cut II Cuts. PEEL COLD!		  
2 - COLOR DESIGN

1) REPEAT - Repeat steps 1-3 above.

2) APPLY - Apply the first layer of SPECTRA™ Cut II Cuts for 6-8 seconds at 302º F using MEDIUM pressure.

3) PEEL - After the garment has completely cooled remove the mylar backing from SPECTRA™ Cut II Cuts. PEEL COLD!

4) APPLY - Apply the second layer of SPECTRA™ Cut II Cuts for 6-8 seconds at 302º F using MEDIUM pressure.

5) PEEL - After the garment has completely cooled remove the mylar backing from SPECTRA™ Cut II Cuts. PEEL COLD!

6) COVER - Cover both layers with either Kraft paper or Teflon and heat apply again for 6-8 seconds using the same temperature and pressure. PEEL HOT!

All technical information and recommendations are based on tests we believe to be reliable. However, we cannot guarantee performance under conditions not under manufacturer's control. Before using, please determine the suitability of product for it's intended use. The user assumes all risk and liability whatsoever in connection with the use of this product. Seller's and manufacturer's only obligation shall be to replace such quantity of the product proved to be defective by the manufacturer.