Recommended Subtrates: Imprintables Prints for Lights will adhere to almost any white or light color fabric, including Cotton Polyester, poly / cotton blends, Fleece, Nylons, Spandex and MESH.
Recommend Application for Imprintables Prints for Lights
Application Instructions:

1) PREHEAT GARMENT - It is extremely important to preheat the garment before application. Press garment for 3-5 seconds to remove moisture and chemical treatment from the transfer area.

2) WEED - Peel excess material away from the design. Leave only the design on the paper backing.

3) POSITION - After preheating the garment, position the weeded design face down onto the garment.

4) HEAT APPLY IN TWO STEPS -
1) - Heat apply the design for 3 seconds at 305º F using MEDIUM pressure. PEEL COLD!

2) - Cover design with Solution™ Kraft Paper and heat apply again for 8 seconds at the same temperature and pressure.

OR

5) HEAT APPLY IN ONE STEP -
1) - Heat apply the design for 10 seconds at 305º F using MEDIUM pressure. PEEL HOT!
 
CARE INSTRUCTIONS:
** Turn garment inside out & machine wash in warm or cold water - mild detergent.
** Do not bleach.
** Product can be dry-cleaned.
** Do not iron directly on design.

All technical information and recommendations are based on tests we believe to be reliable. However, we cannot guarantee performance under conditions not under manufacturer's control. Before using, please determine the suitability of product for it's intended use. The user assumes all risk and liability whatsoever in connection with the use of this product. Seller's and manufacturer's only obligation shall be to replace such quantity of the product proved to be defective by the manufacturer.